BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
TROUBLESHOOTING
Error
Possible cause
Help
Too little or no pressure
in the tool
The pressure reducer has not
been opened
Check the pressure reducer’s
setting – open it if necessary
The air hose leaks
check all connections and seal
leaking components if necessary
No air in the tool
The nozzle is jammed
Clean lean the nozzle and remove
residual paint/varnish
The air supply is being blocked
Check the air supply and the setting
of the pressure reducer – open it if
necessary
Unsteady spray jet
The paint has not been
thinned enough
Thin down the paint according to its
manufacturer’s recommendation
Too little paint in the cup
Fill up the cup with paint (watch its
min./max. capacity)
Too high or too low operating
pressure
Adjust the operating pressure with
the pressure reducer
Dirt and/or residual paint block
the nozzle
clean the nozzle and/or replace it if
necessary
TECHNICAL DATA
Working Pressure:
3 – 5 Bar (44 - 73 PSI)
Max. Pressure
6.3 Bar (90 PSI)
Noise Level:
LpA: = 75 dB (A)
LwA: = 86 dB (A)
Air consumption
(big air spray gun):
6 cfm
Air consumption
(small air spray gun):
3 cfm
