background image

BGS technic KG

Bandwirkerstr. 3

D-42929 Wermelskirchen

Tel.: 02196 720480

Fax.: 02196 7204820

mail@bgs-technic.de

www.bgstechnic.com

© BGS technic KG, Copying and further use not allowed

IMPORTANT NOTES ON PERSONAL SAFETY 

  Operate the tool using common sense. 

  Do not wear loose clothing or jewellery that can be caught by moving parts and cause serious 

injury. 

  Only operate the tool at a safe distance from yourself and other persons 

  Always ensure a firm foothold in order to be able to maintain your balance at all times.  

  Never reach through or over electric cable or air hoses. 

  Always work with a second person present; in event of an accident, this person can call for help 

or medical assistance. 

  Do not use this tool if you are under the influence of medication, alcohol or drugs, or if you are 

tired. Read the package insert of your medicine in order to rule out an impairment of your 
judgement or reflexes. 

  Do not use the device if there is any doubt about the functionality of this tool. 

  Always stay aware. During work, observe your workplace and carry out work with utmost care. 

  Before use, check the tool for damage. If a part is damaged, use the tool again only after all 

damaged parts have been repaired by an authorised specialist. 

 

OCCUPATIONAL SAFETY 

Always wear suitable protective equipment when using pneumatic tools.

 

Always wear anti-slip safety shoes if you are working with pneumatic tools. 

 

 

Always wear work gloves if you are working with pneumatic tools. 

 

 

If you have long hair, always wear a hair net if you are working with pneumatic tools 
that are equipped with motorised rotating or moving components. 

 

 

Always wear approved safety glasses if you are working with pneumatic tools. 

 

 

Always wear approved hearing protection if you are working with pneumatic tools. 

 

 

 

Always wear an approved dust mask if you are working with pneumatic tools where 
dust can be stirred up or dust is produced. 

 

 
 

Summary of Contents for 8471

Page 1: ...lluminated Keep the work area clean organised dry and free from other materials Do allow untrained persons work with this tool set Ensure that the trigger is located in the OFF position when being connected to the compressed air system Do not carry out any modifications on the tool Use only accessories that are dimensioned for use with compressed air tools e g with impact wrenches for manual use d...

Page 2: ...er to rule out an impairment of your judgement or reflexes Do not use the device if there is any doubt about the functionality of this tool Always stay aware During work observe your workplace and carry out work with utmost care Before use check the tool for damage If a part is damaged use the tool again only after all damaged parts have been repaired by an authorised specialist OCCUPATIONAL SAFET...

Page 3: ... pneumatic tools only use oil for pneumatic tools Drain the compressed air system before each use Water in the air lines leads to a loss of performance and damage to the air tool Clean or replace the air filter on the compressor at the prescribed intervals Only operate the air tool with the maximum pressure specified in the chapter Technical data UNPACKING When unpacking make sure that all parts a...

Page 4: ...s sous propre responsabilité que ce produit Declaramos bajo nuestra sola responsabilidad que este producto folgenden einschlägigen Bestimmungen entspricht complies with the requirements of the est en conformité avec les réglementations ci dessous esta conforme a las normas Angewandte Normen GHQWL FDWLRQ RI UHJXODWLRQV VWDQGDUGV Norme appliquée Normas aplicadas ppa Frank Schottke Prokurist BGS tech...

Reviews: