BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
CONTROL PANEL
1
Brightness indicator
2
ON/OFF switch
3
Brightness regulator
4
Battery indicator
5
Bluetooth indicator
6
Indicator for USB output
7
Selector button
8
USB output socket
Brightness Indicator
The brightness indicator shows the actual adjusted brightness in following 4 percent steps:
10% to 25%, 26% to 50%, 51% to 75% and 76% to 100%.
ON/OFF Switch
Press switch ON/OFF for longer than 2 seconds to switch on or off the lamp.
Brightness Regulator
Turn the regulator to the right to increase or turn left to decrease the brightness. There are 30 steps
for regulating the brightness.
Battery Indicator
The battery indicator consists of 4 white LED, which are used to monitor the battery and shows the
charge status in steps of 25%, 50%, 75% and 100%.
•
The battery indicator lit when the lamp is on and shows the current charge level. If only the 25%
LED lights, the battery is almost empty and needs to be charged. Attention: The battery will be
damaged if it stays empty all the time.
•
During charging, the battery indicator flashes. When all four LED are lit solid, the battery is fully
charged.
Bluetooth Indicator
This indicator lamp flashes when the Bluetooth is ready to pair and lights constantly when a Bluetooth
device is already paired and connected.
Indicator for USB Output
This indicator lamp lit when the 5V USB output is active. If a device is connected to the USB output, it
will be charged.
Selector Button
This switch is needed to toggle between following modes:
1. Press the button one time to pair or switch on the Bluetooth.
2. Press the button twice times to switch on USB output and switch off the Bluetooth.
3. Press the button three times to switch on USB output and Bluetooth.
4. Press the button for longer than 2 seconds to switch off the Bluetooth and USB mode.
USB Output Socket
1. Connect the USB A plug of your mobile device charging cable with the USB-A socket installed in
the lamp and the other end of the cable to your mobile device.
2. Press the selector button to turn on the USB output, the indicator lamp for USB output lit.
Pairing Bluetooth Device
1. Press the selector button to turn on the Bluetooth, the Bluetooth indicator lamp flashes and the
lamp gives an acoustic feedback: “The Bluetooth is ready to pair”. Note: If the indicator lamp
lights constantly, that means a Bluetooth device is already paired and connected.
2. Find the Bluetooth Audio "BT Speaker" in your mobile device and connect it. If it is connected, the
Bluetooth indicator lamp lights constantly and the lamp gives an acoustic feedback: “The
Bluetooth is connected....”.
