BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
CONTINUITY MEASUREMENT
1. Switch off the ignition of the vehicle.
2. Connect the red measuring cable to the tester and to the red alligator clip.
3. Connect the black measuring cable to the tester and the black alligator clip.
4. Press the "POWER" button to switch on the device.
5. Press the "MODE" button to switch to the "Continuity measurement" measuring mode.
6. The measurement with the alligator clips can now begin; to do this, clamp the electrical
connections of the component to be measured to the 2 alligator clips.
7. If the measured resistance is less than 1 KOhm, "ERR" is displayed and the buzzer sounds. This
indicates that the component has continuity.
REPLACING BATTERY
When
appear on the LCD. It means that battery needs to be replace. Remove all the
connection before replacing the battery or removing the battery compartment. Pay attention to
correct polarity when connecting the battery. Use a new 9V battery and change the battery as
shown in the pictures.
VEHICLE BATTERY CHARGE STATUS
State of charge as a measure of specific gravity and open-circuit voltage
Percent
Specific
Open Circuit Voltage
Charge
Gravity
Cell
6 Volt
12 Volt
24 Volt
36 Volt
48 Volt
100
1,265
2,110
6,33
12,66
25,32
37,98
50,64
90
1,246
2,091
6,27
12,55
25,09
37,64
50,18
80
1,227
2,072
6,22
12,43
24,86
37,30
49,73
70
1,207
2,052
6,16
12,31
24,62
36,94
49,25
60
1,187
2,032
6,10
12,19
24,38
36,58
48,77
50
1,165
2,010
6,03
12,06
24,12
36,18
48,24
40
1,142
1,987
5,96
11,92
23,84
35,77
47,69
30
1,119
1,964
5,89
11,78
23,57
35,35
47,14
20
1,096
1,941
5,82
11,65
23,29
34,94
46,58
10
1,072
1,917
5,75
11,50
23,00
34,51
46,01
