BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
LED EMERGENCY LIGHT
1. Short press the switch and start the device.
2. Press the switch for 3 seconds. The LED light system starts at a continous lighting state.
3. Short Press the switch once again. The light gives out SOS signal.
4. Short Press the switch one more time. The flash light is turned on.
5. Short Press the switch another time. The light and device is turned off.
INDICATOR LIGHT INSTRUCTION
Press the on-off key to check the power status; The data displayed is the percentage of the actual
power on screen.
CHARGING OF THE DEVICE
1. lnserting the matched adapter into socket.
2. lnserting the adapter into 12V/15V input port of the devices.
or
1. Inserting the one end of car charger into the jack of cigar
lighter.
2. Inserting the other end of car charger into the devices.
STARTING 12V VEHICLE
1.
Make sure the power status is no less than 50%
2. Clamp
positive
pole of the battery with
Red clip
and
negative
pole of the battery with
Black clip
.
3. lnsert the devices connector into the 12V START terminal
on the product.
4. Turn the key to 'ON' and start the vehicle.
Attention
:
Do not carry out long attempts to start.
Do not start the engine for a longer period than 3 seconds
and let the device cool down for minimum 10 minute after
starting. Otherwise the device or its wiring may be
damaged.
5. Once the vehicle has started, remove the end of the clamps
from the device immediately.
Pressing this button for 3 second can
turn on the LED lighting system
Battery power status
