BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
USE
Remove high pressure fuel pipe in accordance
with vehicle manufacturer’s instructions.
If possible ensure the engine is warm to make it
easier to removal of the injectors.
Install component (
1
) under the injector body
and tighten the thumb screw down onto the fuel
pipe connection point as shown to hold it in
place.
Connect the slide hammer (
2
) into the inner
thread and remove the injector.
NOTE
If re-using the injector avoid mechanical contact
with the injector tip as damage can result.
Always replace the injector seals (
A
).
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed
of in a manner which is compatible with the environment. Contact your local solid
waste authority for recycling information.
