15
Fig. 8
Fig. 9
4
10
11
13
12
6. 7
8
9
15
3
14
1
2
4
5
6
5
3
8
9
10
11
7
2
1
5.6.4 Stretching of the drive chains
After the first operation hours you possibly experience some extent of release of the drive chain that
will then need to be restretched. Therefore you need to check the chain after the first 10 operation
hours for the first time and then regularly every 60 operation hours.
To accomplish stretching of the chain (refer to figure 9) and:
• remove the safety guard (1) on the chain, remove screw (2) and loosen (without removing) the 4 screws (3)
• loosen nut (6) of the adjustment screw (4) and then screw the adjustment screw tight on nut (5)
• keep tightening nut (5) until chain (7) is completely stretched
• adjust the chain so that you can still provoke some extent of deflection by applying one finger tip
pressure in the middle.
• then make the PTO shaft (8) turn and check for troublefree and effortless turning.
• check the pump chain (9) to make sure that it is excessively stretched and if required adjust it by
loosening the screw (10) and tightening the nut (11).
5.7 Lubrication
Make sure that the motor is switched off and the ignition key has been removed
before performing any maintenance/repair work on the machine.
Your logging winch is equipped with 4 nipples for the lubrication of the upper pulley and lower
snatchblocks as well as the rope fairlead. Additional lubrication is then required on nipple (13) of the
prebraking arrangement (12) (Fig.8).
Perform lubrication every 15-20 operation hours.
improper lubrication may cause dangerous contamination of the clutch sliding parts for
which the manufacturer will accept no liability!
3
Summary of Contents for FSW 5.5 H Evolution
Page 27: ...27 14 FSW 5 5 H EXPLODED VIEW...
