8
Servicing, setup, maintenance and cleaning as well as trans-
porting the machine may only be performed with the motor
turned off and machine parts at a standstill.
In order to minimize hazards and avoid damage, it is essential that
the instructions regarding operation, assembly, maintenance, repair,
malfunctions and similar are complied with. Moreover, the machines
may only be operated, maintained and repaired by persons who are
familiar with the machine and who have been instructed regarding the
hazards. Pertinent accident prevention regulations and any general-
ly recognized safety, occupational health and road traffic regulations
must be complied with.
Persons under 18 years of age may not work on splitters. It is permis-
sible, however, to assign such work to persons older than 16 years of
age, as long as this is necessary for the sake of achieving certain trai-
ning objectives and if safety is guaranteed by the supervision of other
skilled personnel.
The work site must be organized and maintained in such a way that
safe working is possible.
The work site must be kept free of obstacles (tripping hazards). Grit/
sand is to be strewn on slippery and slick areas; sawdust and wood
ash are unsuitable for this. The machine must be set up on level, even
and firm ground.
• The work site must be adequately illuminated.
• A level and stable area with adequate freedom of movement is re-
quired for working.
• Work on the electrical system may only be performed by a qualified
electrician.
• The operator of the machine is required to wear personal protective
equipment, safety boots, snugly-fitting clothing, suitable gloves and
protective goggles.
• The log splitter may only be operated if all of the protective guards
installed or intended by the manufacturer are in place.
• Never leave the running machine unattended.
The work site around the log splitter and/or the routes for transpor-
ting wood to and from the machine must be organized and maintained
in such a way that safe working is possible.
4. SAFETY INSTRUCTIONS
Summary of Contents for HS 71
