17
After refilling the tank with new oil, let the splitter cycle three or four ti-
mes and let the air blow out of the hydraulic loop before closing the cap.
8.3 Sliding pads
Should irregular noisy knocks be heard while the ram is shifting back
and forth, grease the plastic sliding pads located inside the log carria-
ge. Preferably use commercial grease available in your country.
The noisy knocks should disappear after greasing.
Should you detect an unusually larger gap between the push-block
and and the sliding pads (see section 8.4), sliding pads are likely to
be worn out. If so replace them with brand new ones.
To do so, first release both hex nuts (SW 19) on the cylinder flange
(see figure 9).
Now shift the cylinder half way through the log carriage, undo all 4
push-plate bolts and flip the flange off from one side (figure 10) and
take the pad out.
Slightly raise the push-plate up, remove the old pads from underne-
ath the push-block and slip new ones in.(see section 8.4) .
Now screw the pads back to the push-plate, shift the push-block back
against the steel casing and finally screw the cylinder flange to the
steel casing again.
8.4 Consumables
Lower sliding pad (Part no. 53058)
Hydraulic hoses (replace every 4-5 years)
Hydraulic oil and filter cartridge (replace every 3000-5000 operation
hours)
Abb. 9
Abb. 10
Summary of Contents for SM 300
Page 21: ...21 230 V version Components 1 Box K700 2 Overload safety switch 13 5A 3 KB 04 Uc 230V 4 Motor...
Page 24: ...24 15 SPARE PARTS FOR SM 300...
Page 25: ...25...
Page 30: ...30...
