9
● Before operating the machine for the first time inspect and test all
safeties and protection devices (i.e. Two-hands control lever, hand gu-
ards etc...) and safety stops.
● After switching the machine on and before starting to work make
sure that all parts and controls are duly functioning and in place.
● Set up the machine on a firm surface and ensure that a wide but
confined area is available around the machine assuring maximum
working freedom.
● NEVER use the machine for other applications than described under
the sections „applicable use“ and „operating your splitter“.
● Machine instability can result in injury or severe damages. To ensu-
re stability during operation make sure to choose a flat, dry floor free
from any tall grass, brush or other interferences.
● Never stand behind the push-block or near the control handle while
the machine is running. Never reach inside the dangerous area around
the splitter wedge.
● Refrain from working with the log splitter if you are too tired or un-
der the effects of drugs, alcohol or other medicaments.
● Keep your workplace tidy and as clear as possible from surrounding
obstacles to avoid dangerous situations for your own safety!
● Due and proper illumination of the working site must be provided at
all times. Avoid overlaoding your machine.
● Never modify or add parts to the machine.
● DANGER! Do not operate and do not park the machine in rainy wea-
ther. Always operate/store in a dry rooms away from children reach.
● Switch the machine off and disconnect power before:
- Transportation
- Repairs and adjustment works
- Troubleshooting operations
- Cleaning and maintenance works
- leaving the unit unattended (even for just a short time)
● Inspect the machine and fix eventual damages or anomalies before
continuing to work with it:
- all guards must be in faultless state and conditions before starting
to work.
- all parts must be free of faults and defects and duly seated in their
place on the machine
- Eventual defective or damaged guards and parts must be repaired or
replaced with new original ones by a skilled technician or an authori-
sed service centre, unless other instructions are given in this manual.
● Replace safety labels on the machine as they become tore or not
readable any longer.
