8
ASSEMBLY INSTRUCTIONS CONTINUED
3. Connect the cables for the Pulse
Sensors,
Elevation
and
Speed
Switches in the Handrails to the
cables from the Computer Shelf.
Insert the Handrails (G, H) into the
frame in the direction shown in
drawing.
4. Place the Computer Shelf on the
top
of
the
assembled
frame.
Thread the Control Wire and Cable
Wire of the Upright into the tube,
and then pull them out from the
upper hole on the Computer Shelf.
Then place the Computer Shelf on
the Upright and tighten with Allen
Bolt (c).
Note:
When you tighten the screws,
make sure not to damage the
Control wire and Cable wire in the
tube.
BH North America • 20155 Ellipse •
Foothill Ranch • CA • 92610
• Phone 949-206-0330 • Fax 949-206-0013
www.bhnorthamerica.com