19
STEP 7
Refer to Step 8 and Step 9 diagrams for reference on cable installation routing direction.
Remove Threaded Tube Nut from Threaded Tube. Take Cable (21) and tape (use any adhesive tape)
Threaded Tube on to Cable as shown in Figure 7-3 below. This will prevent the Threaded Tube from
sliding on the cable.
Insert cable end shown on Figure 7-3 into front top Left Frame (1) pulley housing (closest to Ellipse
Inner Cap (46)) and feed the cable as shown in Step 8 and Step 9. For the cable routing on the inner
pulleys above the weights refer to Figure 7-4. After cable has been installed on Left Frame (1), install
Threaded Tube Nut on to Threaded Tube and thread the Threaded Tube into the threaded tube housing
shown in Figure 7-1. Tighten the Threaded Tube nut. Insert the opposite end of the cable into the Swivel
Pulley Housing (6) which will be installed between both pulleys as shown in Step 9.
Use the same assembly instuctions as above for the Right Frame (2) and Cable (1).
Figure 7-1
Figure 7-2
Threaded Tube
Threaded Tube
Threaded Tube Nut
Threaded Tube
Housing
Threaded Tube
Housing
Threaded Tube
Taped
Figure 7-4
Figure 7-3
Direction
Summary of Contents for Dual Adjustable Pulley
Page 12: ...12 ASSEMBLY INSTRUCTIONS...
Page 21: ...21 STEP 9 Tighten hardware with wrench...
Page 25: ...25 EXPLODED VIEW DRAWING...
Page 26: ...26 EXPLODED VIEW DRAWING...