15
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(49) Main body.
(78) Main post.
(4) Handlebar tube.
(73) Front stabilizer bar with wheels.
(48) Rear
stabilizer
bar
with
adjustable feet.
(29L) Left footrest.
(29R) Right footrest.
(19L) Pedal left foot.
(19R) Pedal right foot.
(8L) Top focus bar, left.
(8R) Top focus bar, right.
(1) Monitor.
(16) Focus bar spindle covers (L).
(16) Focus bar spindle covers (R).
(22L) Bottom trim covers, left and
right. (L) for the knuckle joints on the
focus bars.
(22R) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars.
(76) Bottom post cover.
Fig.2
NUTS & BOLTS
(5) Spring washer M-8.
(6) Screws Allen M-8x20.
(7) Corrugated washer M-8.
(11) Screws M-8x20.
(12) Flat washer 8,5x36x3.
(18) Screws Allen M-10x78.
(20) Flat washer 10x19x2.
(21) Self-locking nuts M-10.
(24) Flat washer 6x14x2.
(25) Spring washer M-6.
(28) Flat washer 8x24x2.
(30) Screw DIN 603 M-6x50.
(45) Trim cap.
(47) Screw DIN 603 M-8x75.
(80) Flat washer 19,5x38x0,5.
(84) Screws M-4x15.
(85) Flat washer 8x16x2.
Allen key 5 mm
Box spanner.
2. FITTING THE STABILISER
BARS.-
Bring the front stabilizer bar with
wheels (73) to the main body (49)
positioning the wheels at the front of
the unit, Fig.3, insert screws (47), fit
the spring washers (5) and the
corrugated washers (7) and the nuts
(45) and tighten securely.
Take the rear stabilizer bar with
adjustable feet (48), Fig.4, insert
screws (47), fit the spring washers (5)
and the corrugated washers (7) and
the nuts (45) and tighten securely.
3. FITTING THE BOTTOM POST
COVER.-
Take the main post (78) and insert the
bottom post cover (76) in the direction
of the arrow, Fig.5.
4. FITTING THE MAIN POST.-
Bring the main post (78) up to boss on
the main body (49), Fig.6.
Take the tip of the tension cable (79),
sticking out of the bottom of the main
post (78) and connect it to the tension
support (75), as shown in Fig.6A.
Plug connector (86), coming out of the
main post (78), into connector (74),
coming out of the boss on the main
body (49), Fig.6A.
Slip the main post (78) over the boss
(49) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Summary of Contents for EVO C1000 YC1000
