13
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(29) Screw M8x20.
(27) Washer D10.
(34) Screw M4x10.
(37) Screw M6x15.
(33) Screw M4x16.
(38) Screw ST4x16.
(36) Washer D6.
(28) Washer D10.
(103) Washer D17.
(26) Screw M10x70.
(102) Screw M10x55.
(35) Screw D10×45×M6×20.
(39) Screw M10x20.
(101) Screw ST4x12.
(32) Nut M10.
(31) Washer D8,5xD20xt1.5.
Wrenches.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (2) to the main body (1)
positioning the wheels at the front of
the unit, Fig.3, insert screws (26), fit
the spring washers (27) and the
corrugated washers (28). Use the
5mm Allen key to tighten securely.
Take the rear stabiliser bar with
adjustable feet (3), Fig.4, insert the
bolts (26); fit the washers (27), the
corrugated washers (28) and tighten
securely.
3. FITTING THE MAIN POST.-
Bring the main post (4) up to boss on
the main body (1), Fig.5.
Plug connector (12), coming out of the
main post (4), into connector (11),
coming out of the boss on the main
body (1), Fig.5.
Slip the main post (4) over the boss (1)
on the main body, Fig.5, making sure
not to snag any of the cables. Fit the
screws (39), the washers (27), (28),
(14) and the screws (102), the washers
(14) and the nuts (32), Fig.5. Tighten
securely.
4. FITTING THE FOCUS BARS.-
Insert the focus bar spindle (25)
through the spacer bushes on the
main post (4), Fig.5, leaving it centred.
Fit the spacer washers (103) as
shown in Fig.6. Insert the left focus
bar (5) (marked with the letter “L”)
onto the focus bar spindle (25), Fig.6,
then fit the right focus bar (6) (marked
with the letter “R”) on the other end of
the spindle. Fit the washered bolts
(29) and the flat washers (31) and with
the help of the box spanners tighten
securely.
Take the front cover (17) and rear
cover (16) and screwed with screws
(33).
5. FITTING THE FOOT BARS.-
Take the right foot bar (8) and position
it on the “U” at the bottom of the right
focus bar (6), Fig.7.
Insert screw (37), as shown in Fig.7A,
then fit the flat washer (36) and the
self locking nut (35), and tighten
securely.
Take the left foot bar (5) and go
through the same assembly procedure
as with the right.
Summary of Contents for G2383N
