13
PRECAUTIONS!
Consult
your
doctor
before
beginning to use this appliance.
This advice is especially important
for those suffering from health
problems.
•
Not recommended for use by
children under 14 and always under
adult supervision.
•
Its soft couch can support the whole
body and its soft armrests and foot
support
make
exercise
more
comfortable and safer.
ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there.
The assistance of a second person is
recommended for assembling this unit.
Take the components out of the box
and make sure that you have all of the
pieces, Fig.1:
(1) Front frame.
(2) Nylon Strap.
(3) Rear frame.
(4) Loop strap.
(5) Front Heel Holder.
(8) Adjustable Boom.
(12) Safety Hook.
(21) Strap Lock.
(26) Rod Cap
(29) Handlebar.
(31) Rear Heel Holder.
(35) Foam Bed.
(49) Rear Foot Caps
(53) Front Foot Caps.
(13) Washers D-8.5
(14) round washers D-8.5
(15) Locked nuts M-8.
(27) Washers D12.
(32) Pin D9,5.
(37) Cap D27.
(38) Screws M-8x60.
(43) Screws M-8x12.
(46) Screws M-6x20.
(51) Screws M-6x15.
Allen wrench 5
Allen wrench 6
Double hex. and Phillips spanner.
ASSEMBLY.-
1.-
Position the main support (1) and
(3) in the direction of the arrow so that
they are set horizontally, as shown in
Fig.3. Place the pin (32), the nuts and
the caps as shown in figs 3.
2.-
Place the support pads (49) and
(53), Fig.3, and secure them using
screws (51) along with the washers
(27) as shown in Fig.4.
FITTING THE BACKREST ONTO
THE SUPPORT.-
3.-
The assistance of a second
person is recommended for this stage
of the assembly.
Take the backrest with pivot arms (19)
and insert them into their grooves in
the bed frames (10) Fig.5, screw with
the screw (43). Secure the pivot plate
with screw (46) with washers (13) and
lock with nut (15) as shown the Fig.6.
Check than the backrest (35) rotates
correctly on the pivot arms without any
stiffness.
4.-
Take the handlebar (29), and enter
in the outer hole the screw (46)
together with washer (14), place it on
the rear frame as shown in Fig.7.
Place the screw (38) with washer (13)
into the inner hole of the handlebar
(29), place washer (13) and securely
tighten the locked nut (15). Place the
cap (37) as shown in fig 7.
Perform similar assembly to the
