9
ELECTRONIC MONITOR
FITTING THE BATTERIES
This monitor uses two 1.5 volt ALKALINE BATTERIES. To fit the batteries, remove the rear cover on the monitor,
Figure 11, and carefully insert the two “AAA” type batteries into the battery compartment making sure that the
battery’s polarity is correct (matching the battery’s + terminal with the + sign inside the battery compartment, and
the - terminal with the - sign). Close the cover.
If, after having switched the monitor on, it displays errors or merely partial segments then remove the batteries
and wait for about 15 seconds before reinstalling them.
Weak batteries (run down) produce a weak digital display (poor contrast) and erroneous readings. Change them
immediately.
Important.
Discarded batteries must be deposited in special containers, Figure 12.
FITTING THE ELECTRONIC MONITOR
Fit the monitor (m) into the boss on the bracket (n), as shown in Figure 13, connect terminal (F) on the middle
cable to terminal (E) for the monitor, Figure 14, then connect terminal (h) on the middle cable to terminal (k), as
shown in Figure 15 for the feedback cable.
ELECTRONIC MONITOR
To give you greater control over the exercise, this electronic unit provides simultaneous read-outs of speed,
distance, exercise time, calories burnt.
The screen will switch itself on automatically as soon as you start exercising or by pressing any key.
The monitor will switch itself off automatically if the unit stands idle for more than 4 minutes, with the screen
displaying the temperature.
A: TIME SETTING
After installing the batteries, the time window will blink in the display.
Press the key to set the hours, wait 5 seconds and the minute window will start to blink; press the key to set the
minutes.
B: TIME FUNCTION
This function counts up in steps of one second, up to a maximum of 99:00 minutes.
Pressing the key for more than two seconds will reset all of the values except time.
1. Press any key to switch the monitor on.
C: DISTANCE FUNCTION
This function counts up in equal distance steps of a fraction of a mile.
Pressing the key for more than two seconds will reset all of the values except time.
1. Press any key to switch the monitor on.
D: CALORIE FUNCTION
This function counts up in steps of one calorie, up to a maximum of 999,9 calories.
Pressing the key for more than two seconds will reset all of the values, except time.
1. Press any key to switch the monitor on.
