YV 20 Vibron
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhnorthamerica.com • Phone 949-206-0330 • Fax 949-206-0350
9
ASSEMBLY INSTRUCTIONS CONTINUED
The assistance of a second person is recommended when assembling this platform.
STEP 1
Position the platform as shown in
Fig.2
, lifting and resting the four feet on a table. At least two people
are needed for this step. When fitting the column, one person should hold the column while the other
one follows the assembly instructions. This will prevent any possible accidents.
STEP 2
Next take the column (1) and put it into assembly position,
Fig.2
, connect terminal (A), sticking out of
the column, (1) with the terminal (B) sticking out of the platform (7).
STEP 3
Next, connect terminal (C), sticking out of the column, to terminal (D), sticking out of the platform (7).
Once all of the terminals have been connected, push them inside the column (1) to protect them and
fit the column (1) on the platform, lining up the bolt holes.
STEP 4
Next take the transportation wheel (40) support along with the lock washers (26) and the flat washers
(25), and tighten securely using the 8mm Allen key.
STEP 5
For the next stage of the assembly it is advisable to place the platform back on the floor with the help
of a second person. Take the handlebar (4) as position it as shown in
Fig.3
, lining up the holes.
Fit the screws (29) and flat washers (6) and use the 6mm Allen key to tighten them securely.
It is possible that the hand straps may have come loose during shipment. Fit them back on their
buckle as shown in
Fig.4
.
