Operating the Ministand
15
Figure 15
Figure 16
Figure 17
4.
Tighten the belt until snug by pulling
gently on the end of it.
Attaching the active sling to
the Ministand
Make sure the sling is correctly installed
around the patient waist (as previously
shown).
Choose the appropriate loop colour according
to the patient needs. Install it into the hooks of
the Ministand™ arm.
Make sure the colour of both loops is the same
on both hooks.
Make sure the loops of the sling are correctly
installed in the hook (Fig. 18). If they are not,
install the loop properly
before
lifting the
patient.
Figure 18
Ensure the patient’s arms are over the sling
and that the sling is not caught on any
obstructions (e.g. Wheelchair brake or
handle). See figure 19.
Figure 19
Transferring the Patient
Before Lifting the Patient:
1.
Lower the boom using “DOWN” button to
its lowest point.
2.
Bring the lift towards the patient so that
the Ministand™ footrest is right in front
of the patient's feet.
3.
Gently place the patient's feet on the
footrest and push the lift until the patient's
shins are touching the pads.
4.
Lock the rear wheels on the Ministand™.
