Biamp RP-S4, Instruction Manual

RP-S4 

Remote Panel (Switches) 

RP-S4:

  The RP-S4 is a remote control panel, which consists of four double-

pole*/double-throw switches mounted on a grey ‘decorator’ style cover plate, 
with a single-gang ‘cut-in’ style PVC electrical back-box and four pre-wired 
pigtails.  The RP-S4 may be used to provide remote control switching as
specified for the following BIAMP products: 
 

products                              functions 

801

 Mic/Line Mixer . . . . . . . . . Main Output (mute) 

601

 Mic/Line Mixer . . . . . . . . . Main Output (mute) 

301

 Mic/Line Mixer . . . . . . . . . Main Output (mute) 

CMA Series

 Mixer/Amplifiers . . . . Main Output (mute) 

IWA250

 In-Wall Mixer/Amplifier . . . Inputs/Outputs (mute) 

VSX41

 Video Switcher . . . . . . . Inputs 1~4 (selection) 

VRAM

 Automatic Mixer . . . . . . . programmable logic inputs 

MSP11

 Signal Processor . . . . . . programmable logic inputs 

MSP22e

 Signal Processor . . . . . programmable logic inputs 

SPM723

 Stereo Preamp/Mixer  .  .  .  programmable logic inputs 

Voltage Control Box

. . . . . . . . Various Products 

                                        Audia (programmable) 
                                        Nexia (programmable) 

Logic Box

 . . . . . . . . . . . . . Various Products 

                                        Audia (programmable) 
                                        Nexia (programmable) 
 

The RP-S4 includes four pre-wired pigtails for ease of installation.  Each pigtail
consists of three 22-gauge wires, which are color-coded for wiring as follows: 
 

White . . . . Up (released - out) 
Red  . . . . Center (wiper) 
Green  . . . Down (depressed - in) 

 
See product manuals for remote control applications and wiring specifics.
Soldered connections with heat-shrink, or properly sized crimp connectors, are
recommended.  See last page for back-box installation & block diagrams. 
* 

NOTE:

  Factory wiring (across both switch poles) provides single-pole 

operation.  This may be modified if double-pole switch operation is desired. 

RP-S4

1

2

3

4

 
 
Momentary Switch Operation:

  From the factory, RP-S4 switches provide a 

‘push-on/push-off’ (latching) type of operation.  For some applications
(

especially when used with the 

RIK

 Remote Interface Kit

), the switch operation 

must be ‘momentary’ (non-latching).  The RP-S4 switches each include a small
removable metal jumper strap which provides the latching function.  For
momentary switch operation, remove the jumper strap from each switch using
needle-nose pliers.  One end of the jumper is under the switch spring, which
may need to be gently moved out of the way.  If latching operation should again
become necessary, replace the jumper straps by reversing this process.

jumper
strap