12
VEGA
Fig. 6.7
Fig. 6.8
Fig. 6.9
Fig. 6.10
6.4 Chargement produits
(with machine off)
6.4.1 Drawer loading
to carry out product loading it is necessary to remove each
drawer by pulling it towards the outside until the locking point
is found. The first three drawers from the top will tilt downwards
to make loading easier.
(Fig.6.9)
.
insert the products starting from the front of the drawer to the
innermost part. Do not leave any space empty
(Fig.6.10)
The clamp of the power cable junction box under
tension (Fig.6.7-pos.1)
For some operations is however necessary operate with the
door open but with the distributor connected. It is possible for
qualified technical personnel, to operate in this way, by inserting
the special plastic key , supplied with the distributor , into the
door switch and rotating it 90° (Fig.6.8).
The opening and the possible connection with the
distributors door open must be performed only by
authorized and technically qualified personnel.
Dont leave the distributor open and unguarded.
Give the key only to qualified personnel.
Every time the distributor is switched on, a diagnosis cycle begins
to check the position of the parts in motion and the number of
motors there are per drawer.
