- 25 -
MAIN ELECTRONIC CONTROL/IGNITION P.C.B.
1 Remove all the body panels (see section "2.2 Case panels"
on page 5).
2 Gain access to the parts located inside the Main electronic
p.c.b. box as explained in the section "2.4 Main electronic
p.c.b. box" on page 6 of this manual.
3 Unscrew the screws "D" (Figure 9.11).
4
Delicately flex the hooks "E" in the directions indicated (Fig
-
ure 9.11) in order to release the circuit from the box.
5 Remove all the wiring connected to the
Main electronic con-
trol/ignition p.c.b
.
6 Remove the
Main electronic control/ignition p.c.b
.
Figure 9 .11
D
E
7 Re-assemble the
Main electronic control/ignition p.c.b.
fol-
lowing the removal procedures in the reverse order.
Important
When re-assembling the
Main electronic control/ignition p.c.b.
:
8 It is not necessary to utilise static protections but it is advis-
able to ensure that the p.c.b. is handled with care and held at
the edges and with clean dry hands.
Attention
After installing the
Main electronic control/ignition p.c.b
. properly
set the parameters.
Warning: After cleaning or replacement as detailed
above, it is deemed necessary to undertake a com-
bustion analysis as detailed in section "11 .3 Adjust-
ment - Chimney Sweep Function" on page 31 .
Summary of Contents for 47-583-46
Page 2: ......
Page 50: ...50 SHORT SPARE PARTS LIST 6 2 3 4 7 8 10 9 11 12 18 19 20 21 13 14 15 16 17 1 5 Figure 21 1...
Page 51: ......
