- 67 -
MAINTENANCE
MAINTENANCE
• Press 17 and the LCD display shows the
number
01
, indicating activation of the
“chimney sweep function” at minimum
output (Figure 9.18).
•
Press the 13 button (Figure 9.14) to con
-
firm the value entered and activate the
function.
Figure 9.18
bar
RESET
Chimney sweep function at maximum
output in domestic hot water mode
• Press 17 and the LCD display shows the
number
02
, indicating activation of the
“chimney sweep function” at maximum
output.
•
Press the 13 button (Figure 9.14) to con
-
firm the value entered and activate the
function (Figure 9.19).
Figure 9.19
bar
RESET
•
To exit the chimney sweeper, reset the
value of parameter
P06
to
00
or wait 15
minutes with the boiler off (
OFF
).
•
Turn the boiler off by pressing the 18 but
-
ton (Figure 9.14) until the message
OFF
appears on the LCD display (Figure 9.20).
Figure 9.20
bar
RESET
9.12 Settings for changing the con
-
trol board
When the control board is replaced, it must
be configured for the exact boiler type.
•
Enter “programming mode” by holding
down buttons 18 and 19 for 5 seconds
at the same time (Figure 9.21). The code
P00
appears on the display, indicating en-
try into “parameter P00” (Figure 9.22).
Figure 9.21
13
14
16
17
18
19
Figure 9.22
bar
RESET
• Scroll through the various parameters us-
ing 13 or 14 until the LCD display shows
the message
Cod
, indicating entry into
“parameter Cod” (Figure 9.23), and then
displays three dashes “
- - -
”.
Summary of Contents for Basica Cond 25S
Page 1: ...User manual and installation instructions Basica Cond...
Page 71: ......
