- 68 -
MAINTENANCE
MAINTENANCE
Figure 9.23
bar
RESET
• Press the 17 button to set “
2 -°-
”, then
press 13 to confirm the 2 and go to the
next segment.
• Press the 17 button to set “
2°7 -
”, then
press 13 to confirm the 7 and go to the
next segment.
• Press the 17 button to set “
2°7°5
”, then
press 13 to confirm the 5 and go back to
the list of parameters.
•
The code
P10
appears on the display, in-
dicating entry into “parameter P10” (Fig
-
ure 9.24).
Figure 9.24
bar
RESET
•
By using buttons 16 or 17 (Figure 9.21)
it is possible to modify the value of pa-
rameter P10 (00=
M270V.2025 SM
or
01=
M270V.2530 SM
) (Figure 9.25).
Figure 9.25
bar
RESET
•
Press 13 or 14 (Figure 9.21) to confirm the
value entered and return to the list of pa-
rameters (Figure 9.24).
•
Press the 18 button (Figure 9.21) to exit
“programming mode”.
•
Enter “programming mode” by holding
down buttons 18 and 19 for 5 seconds
at the same time (Figure 9.21). The code
P00
appears on the display, indicating en-
try into “parameter P00” (Figure 9.26).
Figure 9.26
bar
RESET
• Scroll through the various parameters us-
ing 13 or 14 until the LCD display shows
the message
Cod
, indicating entry into
“parameter Cod” (Figure 9.27), and then
displays three dashes “
- - -
”.
Figure 9.27
bar
RESET
• Press the 17 button to set “
1 - -
”, then
press 13 to confirm the 1 and go to the
next segment.
• Press the 17 button to set “
1°9 -
”, then
press 13 to confirm the 9 and go to the
next segment.
• Press the 17 button to set “
1°9°8
”, then
press 13 to confirm the 8 and go back to
the list of parameters.
•
The code
A01
appears on the display, in-
dicating entry into “parameter A01” (Fig
-
ure 9.28).
Summary of Contents for Basica Cond 25S
Page 1: ...User manual and installation instructions Basica Cond...
Page 71: ......
