background image

20  RIVA ADVANCE USER MANUAL

Warranty

For RIVA Residential

Wall Hung Gas Boilers

FIRST 2 YEARS-WARRANTY FOR RIVA SERIES

RESIDENTIAL HOT WATER BOILERS: QHT warrants 

that its wall hung boiler and casing are free from de-

fects in material and workmanship for 2 years from the 

date of installation. If any part on the boiler is found to 

be  defective  within  this  period,  QHT  will  replace  the 

part free of charge.

FIRST  10  YEARS-WARRANTY  FOR  RIVA  SERIES 

RESIDENTIAL HOT WATER BOILERS: Biasi warrants 

that  the  stainless  steel  heat  exchanger  of  the  RIVA 

boilers are free from defects in material and workman-

ship  for  10  years  from  the  date  of  installation.  If  the 

stainless  steel  heat  exchanger  is  found  to  be  defec-

tive within the first 10 years after installation, QHT and 

Biasi will replace the stainless steel heat exchanger.

These  warranties  are  subject  to  the  condition  that  a 

heating  contractor  whose  principal  occupation  is  the 

sale and installation of heating equipment must have 

installed the boiler. PARTS, WHICH ARE COVERED, 

consists of all materials supplied by Biasi, identified by 

QHT’s part numbers in its literature. Other parts sup-

plied by the installer carry their own warranty and each 

manufacturer has responsibility for its own products.

NOTE:  ANY  PART,  WHICH  IS  REPLACED  UNDER 

WARRANTY,  CARRIES  ONLY  THE  UNEXPIRED 

PORTION OF THE ORIGINAL WARRANTY.

OWNER RESPONSIBILITIES:

1.  Provide for proper installation, which includes pres-

sure relief and pressure reducing valves and high 

limit safety controls on closed systems.

2.  Provide qualified periodic service to prolong proper 

operation and service.

3.  Insure that boiler is installed in accordance with all 

codes and ordinances.

4.  This warranty does not apply to boilers, which are 

subject to misuse, abuse, neglect, alteration, acci-

dent, excessive temperature, excessive pressure, 

or corrosive water or atmosphere.

5.  Owner will be responsible for return of faulty com-

ponents to Portsmouth, NH, freight pre-paid.

QHT and Biasi will not be responsible for:

1.  Components  that  are  part  of  the  heating  system, 

but were not manufactured by Biasi or QHT as part 

of the boiler.

2.  The workmanship of the installers of RIVA boilers. 

Furthermore,  this  warranty  does  not  assume  any 

liability  for  unsatisfactory  performance  caused  by 

improper installation.

3.  Any costs for labor to remove or replace the faulty 

component.

4.  Improper boiler application or adjustments, control 

settings, care or maintenance.

5.  Any damage associated with corrosion or leakage 

due to the use of “non-barrier”, plastic pipe in the 

heating system.

*IMPLIED WARRANTIES OF FITNESS FOR A PAR-

TICULAR  PURPOSE  AND  MERCHANTABILITY 

SHALL BE LIMITED TO THE DURATION OF THE EX-

PRESSED WARRANTY. BIASI AND QHT EXPRESS-

LY  DISCLAIM AND  EXCLUDE ANY  LIABILITY  FOR 

CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR 

BREACH OF ANY EXPRESSED OR IMPLIED WAR-

RANTY.

THIS  WARRANTY  GIVES  YOU  SPECIFIC  LEGAL 

RIGHTS,  AND  YOU  MAY  HAVE  OTHER  RIGHTS 

THAT VARY FROM STATE TO STATE.

For prompt warranty service, notify the installer, who, 

in turn, will notify the distributor from whom the boiler 

was  purchased.  If  this  does  not  result  in  corrective 

action,  contact  Biasi  through  Quincy  Hydronic  Tech-

nology (Address Below) with details in support of the 

warranty claim. All claims must be processed through 

proper trade channels. Contact with Biasi directly is not 

recommended for rapid claim settlement.

Quincy Hydronic Technology Inc.,

3560 Lafayette Road, Bldg. 2, Unit A

Portsmouth, NH, 03801

Tel. (603) 334-6400

BIASI BOILER WARRANTY REGISTRATION

IMPORTANT., Registration required. To gain complete warranty

Protection, fill in and mail this card, within 1 year of installation to the address listed below

NAME:____________________________________ ADDRESS:____________________________
CITY:______________________  STATE:________  ZIP:______________
BOILER SERIAL NO.: _______________________  DATE OF INSTALL:_____________________
NAME OF INSTALL CO.:_____________________  ADDRESS:____________________________
CITY:______________________  STATE:________  ZIP:____________
RETURN TO: QHT, INC., 3560 Lafayette Road, Bldg. 2 Unit A, PORTSMOUTH, NH 03801

Summary of Contents for Riva ADVANCE SV

























Reviews: