HR M
ANUAL
O
PERATION
VIA
B
-
TOUCH
Manual version 3.0 (10-10-2017)
en-43
en
Checking HR unit
Use this function to check the operation of the unit.
Run through the various modes in this function to check the
operation of the dampers and fans, as indicated in
Default settings
Restores the default factory settings of the setup menu. The
settings entered in the configuration menu are retained.
Factory configuration
Restores the standard factory configuration. All settings are
then lost.
Note:
n
The installation guide will be restarted.
Reset system
The control panel searches for connection with the attached
units again. Use this function when remedying errors and dur-
ing connection or disconnection of units.
3.8
USB
The control panel is equipped with a USB port to which only a
USB flash drive can be connected. This is used for:
• updating the software
• importing and exporting settings
• exporting usage data
This menu is automatically activated when a USB flash drive is
connected. The menu is closed again when the USB flash drive
is removed.
Caution:
c
Do not remove the USB flash drive during the
updating or during the importing or exporting of
data. This can take several minutes.
Warning:
w
Connection of other electronic devices to the
USB port can cause serious damage to the
control panel or to other electronic
components.
