I
NSTALLATION
H
EAT
RECOVERY
UNIT
en-16
en
Hanging the unit up
1. Mount the electronics module on the side of the heat
exchanger module
.
2. Move the heat exchanger module
into position.
3. Attach the module to the threaded rods with nuts
1
.
Note:
n
Make sure the rubbers and rings
2
for damping stay
in the right place.
Caution:
c
Make sure that the module is hanging level in both
directions.
4. To each threaded rod, apply a lock nut
3
.
5. Move the recirculation damper module
into position.
6. Attach the module in the same way as the heat exchanger
module (steps 2 and 3).
7. Connect the modules to each other with the coupling ele-
ments at top and bottom.
Caution:
c
Adjust the modules individually before they are
connected to each other.
