Bierkühl Oy
+358 440 178 111
Pellonlaita 1, 50600 Mikkeli Finland
www.boscleantec.com
Operation and Maintenance Manual
BOS® Cleantec Duct Cleaning Brushes
SIVU 7
OPERATING AND SAFETY INSTRUCTIONS
PLEASE CAREFULLY OBSERVE THE FOLLOWING BEFORE AND DURING OPERATION:
The machine operator must ensure that the machine is fit for the intended purpose.
The machine operator must ensure that the air supply matches the ratings on the CE plate.
The air must be dry and clean.
All regulatory requirements must be observed.
There must be no flammable particles nor danger of explosion present in the operating
environment.
No flammable or explosive materials or substances must be used or stored at the location
where the machine is used.
The machine must be protected from moisture, vibration and water.
Only use spare parts that are suitable for the machine (are approved by the manufacturer).
Do not cover the machine during operation.
The machine must be kept as clean as possible.
Do not stay continuously in the immediate vicinity of a machine in operation.
The machine must not be used in the vicinity of explosive, toxic or corrosive gases.
The operating temperature must not 40°C or fall below -20°C.
The machine must not be modified in any way.
It is recommended that these machines are operated by two persons at a time, to avoid accidents
caused by the force of the rotating shaft and brush.
The shaft may only be rotated while the brush is inside a duct. Before starting work, make sure the
brush is properly attached.
The person(s) performing the work must, depending on the work performed, wear respiratory
protection, a helmet, hearing protection, safety goggles, clothing and footwear as well as other
personal protective equipment.
