6. Appendix
ORM0043_2
Modulating Controller Application Manual
Page 12
6.2 System Outputs
Controller On
Set active when the controller is powered on
System Fault
Set active when any fault is present in the controller
Manual Mode
Set active when the controller is in manual mode
Opening
Set active when the actuator is opening
Closing
Set active when the actuator is closing
Open Limit
Set active when the actuator is fully open
Close Limit
Set active when the actuator is fully closed
Open Solenoid
Set active when the actuator is opening
Close Solenoid
Set active when the actuator is closing
Aux Solenoid
Set active when there is a common fault
Feedback Fault
Set active when the feedback signal is in fault
Command Fault
Set active when the command signal is in fault
Common Fault
Set active when there is a signal indicating a common fault
Pump Output
Set active when the pump is required to run
Pump Fault
Set active when there is a signal indicating the pump is in fault
Overrun Fault
Set active when the pump has run continuously beyond its maximum allowable time
Acc Press Fault
Set active when the accumulator pressure signal is in fault
Low Press Fault
Set active when the accumulator pressure is below the minimum allowable pressure
High Press Fault
Set active when the accumulator pressure is above the maximum allowable pressure
Low Level Fault
Set active when there is a signal indicating that there is a low oil level
High Temp Fault
Set active when there is a signal indicating that there is high oil temperature
Low Supply Press
Set active when the supply pressure is below the minimum allowable pressure
Supply Press Flt
Set active when the supply pressure signal is in fault
