16
5.2.7 Bale Count Screen
The bale count screen tells you the bale count of the machine. There is a total bale count and 3
resettable bale counts all resettable by pressing the corresponding button on the right-hand side of
the screen.
Figure 10: Bale Count Screen
NOTE
: The bale count only increments when the
‘Retract
Tines’
action is completed as part of the
‘Auto
-
Pickup’
cycle. Therefore, if the
‘Auto
-
Pickup’
sequence is interrupted before the
‘Retract
Tines’
action is completed, or an occasional bale is picked up manually then these bales will not be counted
on the bale count. To return to work screen from this screen, press the
‘Enter’
button located on the
bottom right of the screen.
5.3 Loading bales onto your Transtacker
5.3.1 Opening the Transtacker for Loading
Having entered the field and you now need to open up the Transtacker ready to collect bales as
follows:
1.
Exit
‘Road Mode’
and enter
‘F
ield Mode
’
(see section 5.2.4). Now you will need to engage the
PTO and do the following steps to open the Transtacker.
Figure 11: Extend Guidebar and Pickup Latch Position
2.
Press the Middle Button and move joystick right and hold to Extend the Guidebar. The guide
bar can either be seen in the right-hand mirror or over your right shoulder (Figure 11).
Summary of Contents for Transtacker
