33
NOTE:
Before starting this function, the operator
needs
to ensure that the Turntable is
not lowered
more than half way (45 degrees). Otherwise, the machine will automatically bring the Turntable down
fully without the necessary rotation of the Turntable to be back in its home position. If the Turntable
is less than 45 degrees, it
must
be raised to avoid causing damage to the machine.
5.4.6 Retrieving an erected Stack
To make it easier to retrieve a stack it is advised that stacks are tied together.
1.
If necessary, exit
‘
Road Mode
’
and put Tra
nstacker into ‘Stack Mode’.
2.
Hold down either the top left button and push the joystick forward or press the bottom left
button and pull back the joystick to start the
‘Auto Open’
function (Figure 43).
Figure 46: Tip Bed Up
3.
Pull the joystick back to tip the machine up until it is upright. Backup to the stack until the
platform makes contact with the stack.
Figure 47: Close right and left side gates
4.
Hold down the bottom left button and push the joystick left and right to close corresponding
side gates (Figure 47).
Summary of Contents for Transtacker
