Big Button BB40, Owner'S Manual

6

7

  Direct Code Entry

To set up your remote to control your TV

1.  Press and hold the 

SETUP

 button until the 

green indicator under a mode button stays 
on, then release the

 SETUP

 button.

2.  Press and release the 

TV

 mode button. The 

green indicator for 

TV

 mode blinks, then 

stays lit.

3.  Enter the 4 digit TV code from the code 

tables (on separate sheet). Note: after a 
valid code entry, the green indicator turns 
off.  For an invalid code, the green indicator 

fl

 ashes.

4.  With your device on, press

 POWER

. If the 

device turns off, no further programming 
is required. Note: If some buttons do not 
operate your equipment, try one of the other 
codes for your brand.

Note: Most users will 

fi

 rst set up the remote 

to control their TV. But you also need to set 
up the remote to control other devices you 
want to control:

To set up your remote to control a Cable 

Box

1.  Press and hold the 

SETUP

 button until the 

green indicator under a mode button stays 
on, then release the

 SETUP

 button.

2.  Press and release the 

SAT/CBL

 mode 

button. The green indicator for 

SAT/CBL 

mode blinks, then stays lit.

3.  Enter the 4 digit Cable code from the code 

tables (on separate sheet). Note: after a 
valid code entry, the green indicator turns 
off.  For an invalid code, the green indicator 

fl

 ashes.

4.  With your device on, press

 POWER

. If the 

device turns off, no further programming 
is required. Note: If some buttons do not 
operate your equipment, try one of the other 
codes for your brand. 

  Setup

Battery Installation

1.  On the back of the remote, push down on 

the tab and lift the cover off.

2.  Match the batteries to the + and - marks 

inside the battery case, then insert 2 AA 
Alkaline batteries.

3.  Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the 
buttons are depressed more than 30 seconds. 
This will save your batteries should your 
remote get stuck in a place where the buttons 
remain depressed (e.g., between the sofa 
cushions).

Code Saver

Codes are stored in permanent memory while 
you are changing batteries so you will not lose 
any codes stored in the remote while you are 
changing batteries. 

Power-On Default

The remote powers on in TV mode.

Note when using your remote that you don’t 
need to point it directly at the device you want 
to control. We’ve included transmit LEDs on 
the back of the remote so it works even if you 
point it upwards.