11
8.
If required enter the password for the Wi-Fi connection
9.
Click “Save”
The PDU will now connect and reboot. After it has rebooted it will attempt to
connect to the Wi-Fi signal.
10.
Once the PDU has been connected to the network and has
access to the web,
proceed to the next steps
Replaceable Surge Modules
Remove
1.
Firmly grasp the front top and bottom lip of the surge module
2.
Pull the surge module from the front of the PDU
A slight side to side motion may help release the surge module from the PDU
Replace
1.
Ensure the correct module is being inserted into the correct slot on the PDU
2.
Gently slide the surge module into the PDU until you feel resistance
3.
Firmly push the surge module into the PDU until you hear and feel a click
DO NOT:
Smack the surge module into the slot
Cloud setup
1.
Log in to your MAVbase.com account
2.
Click the Add New button
3.
Click “ADD PDU”
4.
Add the PR-R13PI to your account using the MAC address of the PDU
Surge Protection
Protected Circuit(s)
Replaceable 5100 Total Joule Protection from
the Line to Neutral to Ground circuit.
For use only with SPD Modules specified by
the manufacturer.
This SPD is suitable for use only with
manufacturer’s specified Cat. No. PR-RMS1,
PR-RMS2 replaceable SPD Module. Using
this SPD with other than the manufacturer’s
specified SPD may create a risk of fire or
shock.
This equipment is not suitable for use in
locations where children are likely to be
present
“Cet équipement ne convient pas à une
utilisation dans des lieux pouvant accueillir
des enfants”
Equipment is intended for installation in
Restricted Access Area
“Les matériels sont destinés à être installés
dans des EMPLACEMENTS À ACCÈS
RESTREINT”
