Big Joe CB33 Manual Download

Page: 14 / 170

3-2

BL-CB33-0115 - 03-01-2018

Although a leakage voltage reading of zero volts may
not be possible, a cleaner battery will have more
usable charge for truck operation and not affect opera-
tion of electronic devices on the unit.

3-3.2. Safety Rules

• Wear protective clothing, such as rubber apron,

gloves, boots and goggles when performing any
maintenance on batteries. Do not allow electrolyte to
come in contact with eyes, skin, clothing or floor. If
electrolyte comes in contact with eyes, flush immedi-
ately and thoroughly with clean water. Obtain medi-
cal attention immediately. Should electrolyte be
spilled on skin, rinse promptly with clean water and
wash with soap. A baking soda solution (one pound
to one galleon of water) will neutralize acid spilled on
clothing, floor or any other surface. Apply solution
until bubbing stops and rinse with clean water.

• If truck is equipped with wet cell batteries, keep vent

plugs firmly in place at all times except when adding
water or taking hydrometer readings. Do not allow
dirt, cleaning solution or other foreign material to
enter cells. Impurities in electrolyte has a neutraliz-
ing effect reducing available charge.

• Do not bring any type of flame, spark, etc., near the

battery. Gas formed while the battery is charging, is
highly explosive. This gas remains in the cells long
after charging has stopped.

• Do not lay metallic or conductive objects on battery.

Arcing will result.

• Do not touch non-insulated parts of DC output con-

nector or battery terminals to avoid possible electri-
cal shock.

• De-energize all AC and DC power connections

before servicing battery.

• Do not charge a frozen battery.

• Do not use charger if it has been dropped or other-

wise damaged.

3-3.3. Battery Care and Charging

CAUTION:

Never smoke or bring open flame near
the battery. Gas formed during charging
is highly explosive and can cause seri-
ous injury.

Charge the battery only in areas designated for
that use.

Make certain the charger being used matches the
voltage and amperage of the truck battery.

Before disconnecting or connecting batteries to a
charger, make sure the charger is “OFF”. If an
attempt is made to do this while the charger is
“ON”, serious injury to you, the battery and the
charger could result.

Before connecting the battery cable to the trucks
receptacle, make sure the key switch is off. The
battery cable must be fully connected before the
truck is used. If the plug is not making good con-
tact, heat will weld the two parts of the battery
connector together, making it difficult to remove
and necessary to replace.

Battery terminals should be checked and cleaned
of corrosion regularly. Good battery terminal con-
tact is essential not only for operation, but also for
proper charging of the battery.

The charging requirements will vary depending on
the use of the truck. The battery should be given
an equalizing charge on a weekly basis. This
charge should normally be an additional three
hours at the finish rate.

Make certain battery used meets weight and size
requirements of truck. NEVER operate truck with
an undersized battery.

3-3.4. Battery Cleaning

Always keep vent plugs tightly in place when cleaning
battery. When properly watered and charged, the bat-
tery will remain clean and dry. All that is necessary is
to brush or blow off any dust or dirt that may accumu-
late on them. However, if electrolyte is spilled or over-
flows from a cell, it should be neutralized with a
solution of baking soda and water, brushing the soda
solution beneath the connectors and removing grime
from the covers. Then rinse the battery with cool water
from a low pressure supply to remove the soda and
loosen dirt. If batteries stay wet consistently, they may
be either overcharged or over filled. This condition
should be investigated and corrected.