7
2. Rapidly pump the handle 6-8 times. Leave handle
in down position to expose oil fill plug.
4. Turn release valve clockwise to the closed
position.
5. Jack is now ready for use. Check for proper pump
action.
7. Before raising the vehicle double check and verify
the saddle is centered and also has full contact
with the lifting point.
RAISING THE JACK
1. Block the vehicle’s wheels for lifting stability.
Secure the load to prevent inadvertent shifting
and movement.
2. Position the jack near desired lift point.
3. Set the Parking Brake in the vehicle.
4. Refer to the vehicle manufacturer owner’s manual
to locate approved lifting points on the vehicle.
Position the jack so that the saddle is centered
and will contact the load lifting point firmly.
5. Assemble the handle, ensure that spring clips
align with slots.
6. Close the release valve by turning it clockwise
until it is firmly closed.
BEFORE USE
3. With a flat blade screwdriver, push the oil fill plug
slightly to the side to purge trapped air from
system. (Use caution not to tear or puncture the
oil plug.)
1. Before using this product, read the owner's
manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use.
2. Perform the system air purge procedure. (See
previous instructions for System Air Purge
Procedure.)
3. Check that the pump operates smoothly before
putting into service.
4. Inspect before each use. Do not use if bent,
broken or cracked components are noted.
Summary of Contents for T90203B
Page 12: ...12 ASSEMBLY DIAGRAM...
Page 27: ...27 SCH MA DE MONTAGE...
Page 42: ...42 DIAGRAMA DE ENSAMBLAJE...
