ENTER THE NEW COMBINATION:
1. Turn the dial
LEFT
until the first new number aligns with the
CHANGING INDEX
the fourth time.
2. Turn the dial
RIGHT
until the second new number aligns with the
CHANGING INDEX
the third time.
3. Turn the dial
LEFT
until the third new number aligns with the
CHANGING INDEX
the second time.
4. Turn the dial
RIGHT
approximately ten numbers.
If you feel you have made any errors, however small, in the changing procedure, begin again with the first step in
this section (“ENTER THE NEW COMBINATION”).
Rotate the changing tool approximately ninety degrees
CLOCKWISE
and remove it from the lock.
NOTE: DO NOT PULL OUTWARD ON THE CHANGING TOOL UNTIL IT HAS BEEN FULLY ROTATED TO THE
SAME POSITION AS WHEN YOU FIRST INSERTED IT.
When the safe dial is splined/index to the spindle at #41, do not use a number between “95” and “15” for the third (or
last) number of the combination. When the safe dial is splined/index to the spindle at #50, do not use a number
between “0” and “20” for the third (or last) number of the combination.
CHECK THE NEW COMBINATION:
Check your new combination by following these instructions, which are identical to those under
“TO OPEN”.
1. Turn the dial
LEFT
until the first number of the new combination aligns with the
OPENING INDEX
the fourth time.
2. Turn the dial
RIGHT
until the second number of the new combination aligns with
OPENING INDEX
the third time.
3. Turn the dial
LEFT
until the third number of the new combination aligns with
OPENING INDEX
the second time.
4. Turn the dial
RIGHT
until it comes to a complete stop.
If the dial does not stop, carefully repeat the entire opening procedure at least two more times before calling a
qualified safe technician. DO NOT REMOVE THE BACK COVER OF THE LOCK AND/OR REMOVE ANY
COMPONENTS, AS YOU WILL VOID YOUR WARRANTY!
5. A combination change should be considered successful only when the new combination is successfully tried at
least
[3] three times.
Only then is it safe and permissible to close and lock the safe door.
WARNING! AFTER CHANGING, ALWAYS CHECK YOUR NEW COMBINATION AND RETRACT THE
COMBINATION LOCK BOLT SEVERAL TIMES BEFORE YOU CLOSE AND LOCK YOUR SAFE DOOR.
“Big Red
®
, The Safe-Lock With The Red-Wheels
®
”, Big Red
®
and
DeadLock Technology®
are Trademark of Michael J. Walsh &
Associates, Inc., USA, All Right Reserved.
Foe More Information go to
www.bigredsafelocks.com
© 2003-2012 Michael J. Walsh & Associates, Inc., USA also known as MJWAA, Inc. – Big Red
®
Safe Locks.
Revision 2012 - 1
