Big Sky International, Inc. 970 W Broadway, Ste E289 Jackson, WY 83001 USA
pg 1 of 2
Revised 2019-08-15
www.BigSkyInternational.com 888-535-7085
Big Sky International, Inc. - Wisp 1P “Moon View” (MV) tent revD
Setup instructions:
1)
Clear the ground of any sharp options that will damage the tent floor.
2)
Insert 38cm (15in) pole into foot end pocket, if not already inserted. Pole pocket has flap next to
ground with Velcro that open/closes. (see drawing below)
3)
Lay out the tent.
4)
Stake/peg four (4) main webbing loops
a.
(1) Stake/peg head end with 1cm (3/8in) webbing
b.
There should be a straight line between head and foot end stakes/pegs. (2) Stake/peg foot
end with 1cm (3/8in) webbing.
Note: if strong wind these may be reversed since foot end should be staked/pegged into
the wind, but doing the foot end you will not able to see if ridge line between poles are in
a straight so may need to adjust foot end peg after staking/pegging head end
c.
(3) Stake/peg the non-door side of Wisp tent, it should 90 degrees from straight line
between head end and foot end.
See drawing below:
Note: do not tighten stake/peg webbing loops yet.
** Warning **
The silnylon fabric that we use is very popular for lightweight products, but it
will burn so keep it away from heat or open flame.
We have enclosed a fabric swatch for a test burn… after burning a fabric swatch
you need to decide to either to accept the risk of using the product with this fabric
or return the unused product for full refund
.
