12’–24’ BASIC 6
®
WWW.BIGASSFANS.COM ©2012 DELTA T CORP. ALL RIGHTS RESERVED
10
Mounting Structure: I-Beam
WARNING: The fan should not be installed unless the structure on which the fan is to be mounted is of sound
construction, undamaged, and capable of supporting the loads of the fan and its method of mounting. A structural
engineer should verify that the structure is adequate prior to fan installation. Verifying the stability of the mounting
structure is the sole responsibility of the customer and/or end user, and Big Ass Fans hereby expressly disclaims any
liability arising therefrom, or arising from the use of any materials or hardware other than those supplied by Big Ass Fans
or otherwise specified in these installation instructions.
CAUTION: It is not recommended to mount a Big Ass Fan to a fabricated I-beam. Do not direct mount the fan to an I-beam.
The I-beam on which the fan will mount must be part of the existing building structure.
CAUTION: Install the spacers only if the thickness of the I-beam flange exceeds 3/8” (1 cm). The mounting holes on the
spacer are closer to one edge than the other. Make sure this edge of the spacer is facing the I-beam.
CAUTION: Before beginning installation, confirm that you have the appropriate mount for your roof pitch.
WARNING: Ensure there are no persons below the fan unit during installation!
1. Measure I-beam width
Measure the flange width of the I-beam from which the fan will be hung. Select the upper yoke mounting holes that match the flange
width of the I-beam.
Small Upper Yoke
13-3/4’’ x 10” (349 mm x 258 mm)
I-beam
flange width
Upper yoke
mounting holes
5” (127 mm) to
6-5/8” (168 mm)
Inner holes
>6-5/8” (168 mm) to
8-1/4” (210 mm)
Middle holes
>8-1/4”(210 mm) to
9-7/8”(250 mm)
Outer holes
Large Upper Yoke
18-1/2’’ x 10” (470 mm x 258 mm)
I-beam
flange width
Upper yoke
mounting holes
9-7/8” (250 mm) to
11-3/8” (289 mm)
Inner holes
>11-3/8” (289 mm) to
13” (330 mm)
Middle holes
>13” (330 mm) to
14-5/8” (371 mm)
Outer holes
outer holes
middle holes
inner holes
Upper Yoke
(top view)
Big
Ass
Fans can only be hung from an I-beam or bar joists. See page 12 for bar joist mounting instructions. Consult a
structural engineer for installation methods not covered in this manual.
Summary of Contents for Basic 6
