CLEAR MEMORY
8
Every time you turn
bigtrak
on, this programme is present and ready for
use when you press the key. This key will only work once after the
bigtrak
has been switched on and
before pressing any other keys.
Once you have seen how
bigtrak
works, you will want to start inventing
your own programmes. To programme, you will need to learn what the
other keys do. Practice using each key as you read about it.
Find the key that is marked . This is the CLEAR KEY.
Pressing this key will remove or erase all instructions from
bigtrak
’s
memory. When you erase entries with this key, the entire computer
memory becomes blank and you can then programme new instructions
for
bigtrak
to perform.
When you want to change programmes, is the first key to
press. If you do not press then the entire previous programme
is ‘remembered’ by
bigtrak
, and can be repeated by pressing .
If you add more instructions,
bigtrak
will repeat the first programme and
then perform your new commands when you press .
NOTE:
bigtrak
must be programmed every time you switch it OFF and
ON again
Press to cancel the TEST programme, and read about the next
key, which is .
TEST
CM
GO
GO
CM
CM
CM
CM
GO
GO
GO
Press to action each step programmed into bigtraks memory.
GO
