Expansion mechanism adapter
installation:
1.
Remove the two expansion bolts
using the screwdriver tool provided in
the box
2.
Mount the two expansion adapters
and reinstall the expansion bolts
Silicone spacer installation:
1.
Slide the silicone spacer into the
device until the spacer is located as
shown to the right
20mm+ handlebar adapter set
Use the adapter set on handlebars with inner diameter
larger than 20mm.
Silicone spacer
Expansion mechanism adapter
Start_Guide.indd 8-9
12/06/2019 16:21
FCC WARNING STATEMENT
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End user must follow the
specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The equipment is designed to meet the requirements for exposure
to radio waves established by the Federal Communications
Commission (USA). These requirements set a SAR limit of 4W/kg
averaged over one gram of tissue. The highest SAR value reported
under this standard during product certification for use when
properly worn on the body is 3.442w/kg.
For body operation, this device has been tested and meets FCC RF
exposure guidelines when used with any accessory that contains no
metal and that positions a minimum of 15mm from the body. Use of
other accessories may not ensure compliance with FCC RF
exposure guidelines.
CE WARNING STATEMENT
Use Member States
The radio equipment can be used in at least one of the member state.
Hereby, Bikefinder AS declares that the radio equipment is in compliance
Please contact Support@bikefinder.com to receive full text of the EU
declaration of conformity.
with Directive 2014/53/EU.
The device is designed to meet the requirements for exposure to radio
2.434W/kg for Limbs.
product was tested and recorded the maximum reported SAR value was
limit of 4.0 W/kg averaged over ten gram of tissue when use in Limbs. This
waves established by the European Union. These requirements set a SAR
