3 – OPERATION
Open the platform travel latch (Figure 3-5) and
pivot the platform upright. Platform locking pins
will engage in the pivot locking holes when the
platform is in a full upright position. Verify that
the platform is locked into place.
Figure 3-5. Platform Travel Latch
Verify that the platform is properly attached to
the mounting bracket on the boom end. The
Retaining Pin should be fully inserted through
the platform and the mounting bracket on the
boom end.
WARNING
Failure to verify proper attachment of the
platform to the boom end could cause the
platform to separate from the boom, resulting in
serious injury or death to the operator.
19
Use the ground control panel to operate the
boom lift functions. Raise, lower, extend and
rotate the boom by pressing and holding the
desired
SPEED
and function buttons at the same
time. Become familiar with the location and
function of all controls. Learn to smoothly start
and stop all boom motions.
Fully lower the boom onto the boom rest to
position the platform for boarding. Turn the key
switch to the platform control position.
Raise the safety bar and enter the work
platform. Put on the safety harness and attach
the lanyard to the Fall Protection Attachment
Point on the side of the platform support beam.
Use the platform control panel to operate the
boom lift functions. Raise, lower, extend and
rotate the boom by pressing the desired
SPEED
and function buttons at the same time. Become
familiar with the location and function of all
controls. Learn to smoothly start and stop all
boom motions.
Should the platform become tilted out of the
normal vertical axis, press and hold the desired
SPEED
button and one of the
PLATFORM TILT
buttons at the same time to adjust.
Monitor the Battery Condition Indicator during
operation and charge the batteries as
necessary.
Always fully retract, rotate and lower the boom
to the stowed position before exiting the
platform.
When all boom lift operations are complete, fully
retract the telescoping boom extension. Center
boom over the boom rest and fully lower boom
until seated in the stowed position for transport.
Safety switches prevent outrigger retraction until
boom is completely lowered and stowed for
transport.
Unfasten the safety harness and exit platform.
Disengage platform locking pins and return
platform to a stowed position. Engage the boom
and platform travel latches.
Turn the key switch to the ground controls
position.
Press and hold the outrigger
RETRACT
button
and the
AUTO LEVEL
button until all outriggers are
fully retracted to their upright positions. Inspect
the area beneath lift and trailer for obstructions
before retracting outriggers.
Turn the key switch to the
OFF
position and
remove key.
Summary of Contents for 3632T
Page 1: ...OPERATOR S MANUAL T 134 98 B33 01 0089 3632T ...
Page 42: ...BIL JAX 3632T 40 ...
Page 46: ...BIL JAX 3632T 44 ...
