www.B-TEK.com
2016
Pit Type Truck Scale Installation Manual
10
For each load cell in the scale, a load cell mount kit will be provided. It consists of the following:
• Lower receiver
• Upper Receiver
• (2) 1/16” thick shim plates - #100-66458-2
• (2) 1/8” thick shim plates - #100-66458
• Isolation disc
• Debris foam ring
• (2) grounding straps
• (1) bag containing anti-rotation pin
Note that scale height dimension shown on the supplied drawings include the 1/8” ring plate and both 1/16”
shim plates in the overall stack height. Should additional height need to be made up, an additional 1/8” shim,
part #100-66458, is included for each load cell location.
Load Cell Mount Kit
Anti-Rotation Pin
Debris Foam Ring
Lower Receiver
Isolation Ring
Upper Receiver
Grounding Straps
Shim Plates
It is recommended to layout all foundation base plates
prior to permanently anchoring to the foundation. Set
the foundation plates in place. Do not secure the plates
to the foundation at this time.
Ensure that the foundation base plates are all level with
each other. Shim plates for use on the top of the foun-
dation base plates are included.
Shim plates are 1/8” in thickness and are meant to
make up minor differences in height. The acceptable
height tolerance between all base plates is +/- 1/8”.
Verify with a laser level or transit
If the amount of the difference in height between the
base plates cannot be made up with the use of the
shim plates alone, use non-shrinking grout under the
base plate to bring them uniform in height and/or level
with the other base plates.
Ring Plate
Plate Hardware
Summary of Contents for BTEK BS-FECD-P-CPD-M
Page 1: ...BS FESD P CPR M BS FESD P CPD M BS FECD P CPR M BS FECD P CPD M Models Include ...
Page 2: ...www B TEK com 2016 Pit Type Truck Scale Installation Manual 2 ...
Page 22: ...www B TEK com 2016 Pit Type Truck Scale Installation Manual 22 See larger drawing in packet ...
Page 23: ...2016 www B TEK com Pit Type Truck Scale Installation Manual 23 See larger drawing in packet ...