Bilanciai BTEK BS-FECD-P-CPD-M, Installation Manual

www.B-TEK.com  

2016

Pit Type Truck Scale Installation Manual

20

Aligning the Load Cells

After all cells have been installed adjust the end bumper assembly out till they just meet the wall. This will 

restrict weighbridge movement during the leveling of load cells. Once the load cell assembly has been installed 

it must be checked for correct alignment. Using the B-TEK load cell surface level, supplied to authorized deal

-

ers, attach to the lower diameter of the load cell using the integral magnet. The magnet can be adjusted in and 

out by turning the set screw.

With the level attached to the load cell, verify that the load cell is aligned 

both horizontally and vertically by ensuring that the air bubble is visible 

between marked lines.

If the load cell is out of level, adjustments can be made by realigning the 

foundation base plate.

Repeat the check with the level to verify that the load cell is aligned 

correctly.

Continue to readjust the locating plate as needed.

B-TEK Load Cell Surface Level

Once the entire scale has had the load cell assemblies installed and aligned correctly, readjust all bumper 

checking assemblies to within 1/16” - 1/8”. Prior to drilling, make sure that all deck / cover plates are aligned 

and bolted.

At this time drill and install all of the anchors for the base plates. Anchors are suggested to be 3/4” X 7” long 

wedge anchors. A 3/4” X 36” long drill bit can be used for the holes.

Load Cell Assembly Anchored to Foundation

Load Cell Level