61
DS440IS
Selection
In addition to the weight and the usual weighing symbols, the display shows one of the following
symbols
(
see par. 5.1.1 on page 1-49
).
To set the range, press
DRANGE
, select the values with
SELECT
and enter the numerical values
using the number keys (
par. 5.3 on page.
1-52).
WARNING
The display range described here is independent of the range associated with the outputs (
see
par. 6.2.6 on page 1-62 and par. 6.2.7 on page 1-63
).
Display tare
In addition to the usual weighing symbols, the terminal can also simultaneously display the net
weight and the tare (if present).
The following indications are displayed:
If tare was entered by pressing
and no multiple tares were set up during installation:
Tare: tare value + unit of measurement
The indications
and
will light up.
If tare has been acquired by pressing
and no multiple tares were set up:
Tare: tare value + unit of measurement
The indications
and
will light up.
If the tare is preset (par. 6.2.11 on page 1-66) and multiple tares have not been set:
Tare C: preset tare value + unit of measurement
The indications
and
will light up.
