7
DS440IS
1
GENERAL MATTERS
1.1
Declaration of conformity
The declaration of conformity is attached to the safety instructions enclosed with the supply.
1.2
Foreword
The aim of this manual is to provide the operator, through the use of text and illustrations, with
essential information regarding the installation, safe operation and maintenance of the weighing
system.
This manual must be kept in a safe place where it is readily available for consultation! Always
observe the instructions contained in the manual!
Safe operation of the system is entrusted firstly to the operator who must possess sufficient
knowledge of the former.
The user is responsible for making sure that installation complies with the relative standards in
force.
The equipment must be installed by qualified personnel after reading and understanding the
contents of this manual.
“Qualified personnel” means persons that have received sufficient training and have acquired
enough professional experience to be authorised by the "Person in charge of safety" to perform
installation, use and maintenance work.
Contact your nearest Service Centre if problems occur.
Any attempt on the part of unauthorised personnel to dismantle or modify the terminal is
prohibited; in this event, the warranty will be immediately invalidated and the Manufacturer may
not be held liable for any damage to people or property.
The alteration or removal of the data plates and seals is strictly prohibited; as a consequence,
make sure that all plates and labels are readable and, on the contrary, contact the After Sales
Office.
The manufacturer shall not be liable for any damages caused by incorrect handling of the
terminal.
The information and illustrations contained in this manual were up to date at the time of
publication.
The Manufacturer is committed to constantly improving its products, therefore some components
may be modified.
All the technical information contained in this manual remains the exclusive property of the
manufacturer and may not be disclosed to third parties.
No part of this manual may be reproduced and/or disclosed, either entirely or partially in any
form or by any means, including hard copies, electronic copies or through the Web, without the
written permission of the Manufacturer
It is also forbidden to use this manual for any purpose that is not strictly related to the
installation, use and maintenance of the terminal.
In order to more clearly illustrate certain maintenance or adjustment operations, some of the
illustrations in this manual show the weighing system with the safety guards removed. Never use
the system in these conditions! Remove the guards only for the time strictly necessary to
perform repair or maintenance work and refit them as soon as possible.
