88
DS440IS
6.12 Entry/Exit operations using Licence Plate Data Recall
The RCD Plate code is made up of as maximum of 10 alphanumerical characters which the operator
enters manually and which must be set before each entry weighing operation.
Refer to par. 6.11.1 on page 1-83 and par. 6.11.2 on page 1-85 for the entry/exit procedure. In this
case, the reference key is not
RCD
but
PLATE
.
Remember that in the case of RCD Plate, information about the first weighing is associated with the
licence plate of the vehicle on entry.
The card need not be printed in since the first weighing data can be recalled by setting the vehicle
licence plate again when this reaches the exit.
The procedure can be configured in both modes during the installation phase:
with data print-out;
with data memorising.
The selected mode will appear on the display when the machine is powered.
WARNING
The explanations given in par. 6.11 on page 1-83 about printing, the size of the archive, unused
weight recovery and so forth, are also valid for RCD Plate mode.
In this case however, the
relevant key is
PLATE
and not
RCD
.
