30
Quick Start
Whether on the Basic or Advanced Configuration Mode, click Quick Start link to WAN Port setup
pages.
Step 1: Select WAN port connect mode from the connect mode drop down menu. There are three
types of connect mode to choose from: EWAN, 3G or ADSL.
Step 2: After selecting the connect mode, press Continue to move on to the next configuring page.
There are 5 types of phone service standards available for 3G connect mode while there are 5
types of connection protocols available under ADSL connect mode, 4 types of connection protocols
available for EWAN connect mode.
Each type of connection mode is described in the
following sections of 3G Connect mode, ADSL Connect mode and EWAN Connect mode.
Step 3: After finishing configuring the WAN port connection, click Continue to proceed. The system
will upload and apply the new WAN port configuration to the device.
Summary of Contents for BiPAC 7800GZ
