Part No 501606
6
F041513B
BC2600 Euro
Hydro Series Brush Cutter Owner’s Manual
ASSEMBLY INSTRUCTIONS
Your BILLY GOAT
®
BC Self-Propelled Hydro Brush Cutter
was shipped in one carton, completely assembled except for the
upper handle assembly and the front caster bracket mount. Mounting hardware for the handle and caster bracket mount can
be found in the parts bag. The throttle cable hardware is located on the bracket on the right side of the handle
READ
all safety instructions before assembling unit.
A CB18, C50, SC50 or MCB50 series dry or wet battery with a 17.2 Ah rating is required when
replacing the battery.
Numbers in parenthesis ( ) refer to item numbers in the parts list.
1. Remove unit from carton. Make sure the following items that have been packed with unit:
Upper Handle Assembly, P/N 501010, Electric model P/N 501009
Owner’s Manual, P/N 501505
General Safety and Warnings Manual 100296
Honda or Briggs and Stratton Engine Manual
Warranty Card, P/N 400972
Ty-Wraps (4 ea)
Screwcap 3/8” – 16 X 2” P/N 8041054 (qty 4)
Washer 3/8” flat P/N 8171004 (qty 4)
Nut Lock 3/8”-16 P/N 8160003 (qty 4)
Nut lock #10-24 hex P/N 8164005 (qty 2)
Screw machine flat HD Phil P/N 830514 (qty 2)
Spring pin clevis P/N 501318 (qty 1)
DISCONNECT
spark plug wire before assembling unit.
2. Remove mounting hardware from the hardware bag.
3. Attach the handle to the engine base with the items 72, 73, and 48.
4. Tighten mounting hardware on handle braces (5 and 6).
5. Attach the throttle (82) to the right hand bracket (70) using the hardware items 83 and 84. Tighten securely and make
sure the cable isn’t binding.
6
Attach the Blade drive cable to the lever and seat the plastic insert into the bracket on the left side of the handle
7. Secure the drive and blade cables with the ty-wraps provided
8. Attach the caster bracket frame to the deck with the clip (item 164), make sure the clip section snaps completely around
the neck of the yoke.
9.
Reconnect spark plug wire.
