BC26 HYDRO-DRIVE Owner’s Manual
Part No 501549
8
501549_A_HI
NEUTRAL/FREEWHEEL
1.
Identify the freewheel lever located in front of the right front
wheel when viewing from operator’s station.
2.
Pull lever to initiate freewheel motion.
3.
Push lever in to initiate driver enabled motion.
*****TIPS*****
The best performance is achieved when cutting in dry conditions. The quality of the cut is directly related to ground speed during
cutting. Under most conditions cutting should be done at a slower ground speed. Fast speeds should be reserved for conditions
where weeds and brush are thinned out or not very tall. If the quality of the cut is not satisfactory, attempt at slower speeds.
Fig. 5
Left Handle
Fig. 6
Right Handle
CUTTING
OPERATION
1.
Press blade clutch handle down (See
Fig. 5
) to engage blade. Allow
blade to spin up to normal operating speed.
2.
Pull Forward (See
Fig. 6
) or Reverse Drive lever (See
Fig. 7
) up to
engage transaxle in desired direction.
CLEARING
A
CLOGGED
DECK
DISCONNECT
spark plug wire before servicing unit.
1.
Shut engine off and wait for blade to stop completely.
2.
Disconnect spark plug wire.
3.
Remove clog from cutting deck.
WEAR
durable gloves. Clog may contain sharp materials.
4.
Reconnect spark plug wire.
SHUT DOWN
1.
Release drive lever (
Fig. 6/7
) to disengage transaxle.
2.
Release blade clutch handle (
Fig. 5
) to disengage blade.
3.
(Non-Electric) Move the throttle to the slowest possible position on the
throttle control.
4.
(Electric start models) Turn the key to the OFF position
.
Fig. 8
Freewheel Lever
Fig. 7
Reverse Drive Lever
NOT
FOR
REPRODUCTION
