Part No. 430149 Form No. F110802A
C
E
9
5
Page 16 of 16
Solution
Problem
TROUBLESHOOTING
Before Requesting Service Review These Suggestions
20
Possible Cause
Purchased
from
Purchase
Date
Engine Service and Warranty
Contact your nearest engine manufacturer's
authorized servicing dealer.
22.1
21
Serial Plate
R
ecord your machine model, serial number
and date-of-purchase and where purchased
22
Engine Power
Unit (weight)
@
BILLY GOAT INDUSTRIES INC.
P.O. BOX 308, 1803 S JEFFERSON LEE'S SUMMIT, MO. 64082-2312 / USA
PHONE: 816-524-9666 FAX: 816-524-6983 www.billygoat.com
Poor air performance
Air intake or exhaust clogged.
Clear clog.
Self Propelled Units Only
Self propelled drive will not release
Sticking belt idler arm. Belt fingers bent or
broken.
Check idler. Idler arm mounting screw may be
too tight or too loose. Check belt guide.
Replace if broken.
Machine is difficult to maneuver.
Low tire air pressure.
Inflate front and rear tires to correct pressure.
(See tire pressures on page 14.)
Abnormal vibration
Loose or out of balance impeller or loose
engine.
Check impeller and replace if required. Check
Engine.
Engine will not start
Stop switches off. Choke lever not in on
position. Out of gasoline. Bad or old gasoline.
Spark Plug wire disconnected. Dirty air
cleaner.
Check switches, choke, gasoline and oil. Check
for spark with an approved tester. Clean or
replace air cleaner. Contact qualified service
person.
Engine is locked, will not pull over.
Engine problem.
Contact your nearest engine manufacturers
servicing dealer.
No self-propelling
Transmission not in gear. Operator's bail not
engaging belt or out of adjustment. Worn out or
broken chain. Broken or mispositioned belt.
Check transmission gear selection. Check clutch
cable adjustment, belt and chain (See page 14).
Noisy or broken chain
See Chain Adjustments on page 14.
No chain lubrication. Chain out of alignment or
over tensioned.
WARRANTY PROCEDURE
Please fill in the WARRANTY CARD and send the upper part to Billy Goat.
The WARRANTY terms are stated on the lower part which remains with the
user. Whenever a Billy Goat Machine is faulty due to a defect in material
and / or workmanship, the owner should make a warranty claim as follows:
The Machine should be taken to the dealer from whom it was
purchased or to an authorized Billy Goat dealer.
The owner should present the remaining half of the Warranty
Registration Card, or, if this is not available, the invoice or receipt.
The Warranty Claim will be filled in by the authorized Billy Goat
Dealer,who will send it with the faulty part to Billy Goat headquarters.
The Quality / Service department at Billy Goat headquarters will study
the claim and parts and will notify their conclusions.
The decision by the Quality / Service department at Billy Goat
headquarters to approve or reject a Warranty claim is final and
binding.
Note:
To process a Warranty Claim, it is necessary to quote the Model
& Serial number who are printed on the Billy Goat Serial Plate.
R
1803 S. Jefferson
P.O. Box 308
Lee's Summit,
MO 64063 / USA
Tel (816) 524-9666
Fax (816) 524-6983
Model
Serial No.
Unit(Weight)
Engine Power
lbs.
kg
kW
rpm
115 dB
