RUNNING/ CHARGING DC APPLIANCE
1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the
“Charging the
Power Pack”
section.
2. Make sure the total wattage of the appliance is
within the range of the Power Pack.
3. Make sure that the Clamp Power Switch and
appliance are off.
4. Plug the appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and unplug the
appliance.
RUNNING/ CHARGING USB APPLIANCE
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the “
Charging the
Power Pack
” section.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB
Port.
MAINTANENCE & WARRANTY
TO PREVE
N
T SERIOUS I
N
JURY:
Unplug the Power
Pack, turn the Clamp Power Switch off and allow
Power Pack to cool completely before performing any
inspection, maintenance, or cleaning procedures.
BEFORE EACH USE,
inspect the general condition of
the Power Pack. Check for: loose hardware,
cracked or broken parts,
damaged electrical wiring or cable insulation, and
any other condition that may affect its safe operation.
1. Keep unit clean and clamps free of dirt, debris, or
grease
2. For longer working life, protect Power Pack from
sunlight and moisture.
3. AFTER USE, wipe external surfaces of the Power
Pack with clean cloth.
4. CONTAINS NON-SPILLABLE, SEALED LEAD-ACID
BATTERY. BATTERY MUST BE RECYCLED
Battery Replacement and Disposal
WAR
N
I
N
G! To prevent damage or injury,
replacement battery must be identical to original.
LEAD BATTERY MUST BE RECYCLED.
Replace the Battery when the red light comes on
while pressing the Battery Test button after
recharging.
1.
Remove all screws from the back of the case and
lift off the panel.
2. Lift out the Battery without damaging the circuit
board.
Note:
Notice how the red and black cables connect to
the old battery and make sure to keep them in place,
connecting them to the new battery.
3. Detach the recharging wires and Battery Cables
from the battery terminals.
4. Position the replacement battery with the label
facing out, and make sure the
red (+)
recharging
wire and Battery Cable is attached to the
positive
(+)
battery terminal. Connect both of the
recharging wires and Battery Cables.
5. Carefully slide the Battery into the compartment
without damaging the circuit board.
6. Replace the back panel and the screws.
WARRANTY
The main unit of jump starter enjoys 1 Year warranty to be
free from defects in use due to materials or quality problem.
This warranty covers the cost of the defective product only
and does not cover the cost of installation. we reserves the
right to refuse credit in the event that any damage to the
product resulted from collision, improper installation, or
other customer abuses.
This policy extends only to the original purchaser of the
product and is nontransferable.
If any query or want more information, feel free to contact
our Customer Support:
(888) 680 2849
or send mail to:
inquiry@bilthardusa.com.
4